Jim Throne on October 20th, 2006

Jim Throne, Sherwood Technologies, Inc., Dunedin Florida 34698 Copyright 2006 Introduction Nearly all thermoforming processes employ mechanical assists to differentially stretch the heated sheet prior to contact with the mold surface. The mechanical assist is usually referred to as a plug. It has always been assumed that, as the plug enters the hot sheet, the […]

Continue reading about Does the Thermoforming Sheet Slide on the Plug? – Part 1

Jim Throne on October 4th, 2006

Individual Power Points Power Point of Thermoforming Conference 09-06 Title Page Power Point of Thermoforming Conference 09-06 Heating Page Power Point of Thermoforming Conference 09-06 Stretching Page Power Point of Thermoforming Conference 09-06 Trimming Page One ZIP File ZIP File of Four Power Points of Thermoforming Conference 09-06

Continue reading about Thermoforming Conference 09-06